Tools needed: Phillips Screw Driver, Flat head Screw Driver, Oven, & Oven gloves.

Step 1. Remove OEM corner light by removing the only visible screw that connects the corner light to the chassis. (You might have to pull a little hard to get it off.)

Step 2. Twist and remove the bulb from the assembly. You should now be holding the corner lamp in your hands.

Step 3. Put one corner lamp face up on a baking sheet and set the oven to 300 degrees. Let it sit in there for about 5 minutes. Watch it the whole time because oven settings are all different. This will allow the silicone lining to soften.

Step 4. Remove from oven and begin carefully prying it open. This shouldn't take more than a few seconds but be careful.

Step 5. Using a flat head screw driver remove the side reflector. Should easily come off.

Step 6. Using a phillips screw driver remove the screw that attaches the amber bulb cover.

Step 7 Put gray half back into oven for 3 minutes or so to soften the silicone lining again and when you remove it quickly put both pieces back together.

Step 8. Reinstall

This is the method I used to clear out my corner lights and I haven't had a problem for the past 4 years since I've done this but Follow these instructions at your own risk

- Thanks to Ka24deturbo of Odyclub for the write up.